Osmosis membrane 4040 2700 GPD TWRO Aquaporin Inside

AQUAPORIN 4040 TWRO 2700 GPD MEMBRANE

Aquaporin Inside® Drinking Water Reverse Osmosis (DWRO™) membranes are biomimetic elements that are inspired by aquaporin proteins to provide unique properties. These membranes can be easily integrated into any residential or commercial point-of-use reverse osmosis system in standard configurations.

Optimization of the performance of the AQUAPORIN 4040 membrane

AQUAPORIN 4040 membranes are thin film composite membranes packaged in a spiral wound configuration, which offer many advantages over other module designs for most reverse osmosis applications in water treatment.

The spiral-wound configuration offers lower replacement costs, simpler plumbing systems, easier maintenance and greater design freedom than other configurations, making it the industry standard for membranes. reverse osmosis and nanofiltration in water treatment.

It is important to strictly follow the system start-up steps to prepare the membranes for their normal operation and to avoid their deterioration under the effect of water overfeeding or hydraulic shock. The operating parameters will comply with the specifications and the quality of the water produced as well as the performance objectives can be achieved if the start-up steps are respected.

Before launching the start-up procedures, it is advisable to check the pre-treatment, to check that the membranes have been correctly installed, that the calibration of the measuring instruments is correct and to carry out all other checks necessary before start-up.

It is important to avoid sudden changes in pressure or flow rate of cross-flow filtration during start-up, shutdown, cleaning or other cycles in order not to damage the membrane.

4040 Osmosis Membrane Maintenance Tips

At start-up, it is recommended to gradually transition to the operational working state by increasing the supply pressure in stages every 30-60 seconds. The programmed operational rate should be reached in 15 to 20 second increments. Permeate produced during the first hour of operation must be drained.

After impoundment, the membranes must remain wet. If the operating limits and guidelines given in this sheet are not strictly adhered to, the warranty will be null and void.

It is recommended to immerse the membranes in a preservative solution during prolonged shutdowns of the system in order to avoid any biological proliferation. The customer is fully responsible for damage caused by certain chemicals or lubricants incompatible with the membrane.

The maximum pressure drop in a pressure tube is 3.4 bar (50 psi). Static back pressure on the permeate outlet should be avoided at all times.

It is important to note that the use of this product does not in itself guarantee the elimination of cysts and pathogens from the water. Their reduction depends on the design, operation and maintenance of the system.

Benefits of the Aquaporin 2700 GPD membrane:

• Filtration efficiency: thanks to its biomimetic properties, the Aquaporin Inside® membrane is able to very effectively filter impurities and contaminants present in the water, including bacteria, viruses, heavy metals and chemicals .
• Reduced energy consumption: The Aquaporin Inside® membrane requires less pressure for water filtration, which reduces the overall energy consumption of the water treatment system.
• Increased Durability: Due to its biomimetic design, the Aquaporin Inside® membrane is more resistant to fouling and wear than traditional membranes used in water treatment systems.
• Low maintenance: the Aquaporin Inside® membrane requires minimal maintenance, which reduces maintenance costs and frequency.
• Adaptability: Aquaporin Inside® membrane elements are available in standard configurations and can easily be integrated into any conventional residential or commercial point-of-use reverse osmosis system.

Precautions for use:

1. Discard permeate from first hour of use: Not to be used for drinking or preparing food.
2. To prevent biological growth during prolonged shutdown periods, it is recommended that the membrane elements be immersed in a preservation solution.
3. It should be stored dry in the room and at a temperature between 5-35°C / 41-95°F.
4. It should not be stored in direct sunlight.
5. Keep items wet at all times after initial wetting, even during extended downtime.