This special drive LED is powered by 12 or 24V DC (direct current).
It requires installing a special transformer stable LED 12V or 24V.
It may be controlled with a remote control for varying the light intensity of bands or LED bulb LED MR16 12V.
The supplied infrared remote provides direct access four strengths:
25% 50% 75% and 100%.
Ability to manipulate directly on the drive, then to regain control by remote control infra red.
Even if you just set an intensity of 100% on the drive LED wall, the remote will still be able to decrease and increase the intensity of LEDs.
LED illumination of the button surface or the remote.
You can store 4 custom lighting states (simply by pressing for 3 seconds).
Comes with a box that allows the fixing to a wall or insertion into a wall.
Input voltage: 12V/24V DC Max 6A (72W)
Output voltage: 12 V DC
Material: PVC
Dimensions: 87 x 87 x 38mm
0-100 percent brightness adjustment, infinite gradation style dimming and button IR remote wireless, easy to use,
256 levels of gray, soft and smoothly, without flickering.
Digital PWM dimming + programs without inrush current, the duration of the longest life of the LED.
4 modes of DIY, with Fluorescent Indicator & shutter delay button, users friendly.
When the load constant current / voltage is above, add a repeater to extend the extra power.
An ON / OFF button which alone provides an ignition or a fade, not a stroke, the ignition or extinction therefore takes about 2 seconds to go from 0% to 100% or 100 Ignition % to 0% for extinction. So it's a very good thing because it lets your little eyes not to be assaulted by the light of a sudden.
A second function (OFF Delay) allows you to get within 30 seconds to extinction.
2 buttons + and - are used to increase or decrease the brightness in steps of 1 or 1 / 256 th ... is an ultra precise setting if you want a very specific level of brightness which may be the case for doing photography for example.
The next 4 preset buttons for 25%, 50%, 75% and 100% brightness.
Finally we have 4 buttons numbered 1 through 4. This is actually the settings you'll be able to save yourself or if you want an accurate picture brightness. Example you are around 35% and the power you like, press the number 1 for a few seconds until the dimmer saves this setting you mean by flashing the LED located in the control transparent rectangle over the button of the drive.
You can save 4 settings to suit your specific personal choices.
|
| 
| 
