BIG BLUE filter holder with 10-inch inlet / outlet 1"1/4
Filter holder to be installed on the mains water after the meter, to treat the whole house.
Installing a pressure reducing valve set at 7 bar is highly recommended if your facility is subject to variations successor of excess pressure to use filters doors.
By shunt, with by-pass kit, it helps to maintain a water supply even during cartridge replacement.
It is used to filter water from the house, because his cartridges from 12 to 13 cm conviennet perfectly.
It is housed in many applications: purification, reverse osmosis, softener, water fountains ...
The filter holder is made of polymeric food-quality, compliant with FDA and EEC, with a decompression button to purge.
It is used for filtration of suspended solids in drinking water, drilling or rain.
Its height of 10 "can be adapted to many types of cartridges.
It is designed to ensure maximum safety for filtering drinking water and for the development of other liquids.
Support attachment (bracket) will help you easily install your filter holder.
A special wrench is provided for easy screwing and unscrewing the main part of the room, to replace the cartridge and clean the filter.
O-ring is in FTEs.
You can install it in series, in order to conduct a series of filtrations different sediment, bad taste, bacterial viruses.
Height : 333 mm
Width : 180 mm
Maximum pressure : 7 bars at a temperature of 20 ° C
(Tested at a pressure of 21 bars)
Input / Output 1 inch : 25 mm
Maximum water temperature : 37 ° C
Max. optimal filtration : 2 m3 / h
(Depending on cartridge installed)
|
| 
| 
